Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 146)

clear lacp singleportlag
4-42 Port Configuration
previous LAG member ports comes up connected to the same switch as before the LAG went
down.
Example
This example enables the formation of single port LAGs:
D2(su)->set lacp singleportlag enable
clear lacp singleportlag
Use this command to reset the single port LAG function back to the default state of disabled.
Syntax
clear lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the single port LAG function back to disabled:
D2(su)->clear lacp singleportlag
show port lacp
Use this command to display link aggregation information for one or more underlying physical
ports.
Syntax
show port lacp port port-string {[status {detail | summary}] | [counters]}
Parameters
Defaults
None.
port port‐string Displays LACP information for specific port(s). For a detailed description
of possible port‐string values, refer to “
Port String Syntax Used in the CLI ”
on page 4‐1.
status detail |
summary Displays LACP status in detailed or summary information.
counters Displays LACP counter information.