Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 32)

Factory Default Settings
1-4 Introduction
Spanning Tree edge port
administrative status Edge port administrative status begins with the value set to false initially after
the device is powered up. If a Spanning Tree BDPU is not received on the
port within a few seconds, the status setting changes to true.
Spanning Tree edge port
delay Enabled.
Spanning Tree forward
delay Set to 15 seconds.
Spanning Tree hello
interval Set to 2 seconds.
Spanning Tree ID (SID) Set to 0.
Spanning Tree maximum
aging time Set to 20 seconds.
Spanning Tree port priority All ports with bridge priority are set to 128 (medium priority).
Spanning Tree priority Bridge priority is set to 32768.
Spanning Tree topology
change trap suppression Enabled.
Spanning Tree version Set to mstp (Multiple Spanning Tree Protocol).
SSH Disabled.
System baud rate Set to 9600 baud.
System contact Set to empty string.
System location Set to empty string.
System name Set to empty string.
Terminal CLI display set to 80 columns and 24 rows.
Timeout Set to 5 minutes.
User names Login accounts set to ro for Read-Only access; rw for Read-Write access;
and admin for Super User access.
VLAN dynamic egress Disabled on all VLANs.
VLAN ID All ports use a VLAN identifier of 1.
Host VLAN Default host VLAN is 1.
Table 1-1 Default Settings for Basic Switch Operation (Continued)
Feature Default Setting