Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 296)

set policy rule
9-10 Policy Classification Configuration
set policy rule
Use this command to assign incoming untagged frames to a specific policy profile and to VLAN
rules.
This command has two forms of syntax—one to create an admin rule (for policy ID 0), and the
other to create a classification rule and attach it to a policy profile.
set policy rule admin-profile {vlantag data [mask mask] admin-pid profile-index}
[port-string port-string]
set policy rule profile-index {ether | ipproto | ipdestsocket | ipsourcesocket |
iptos | macdest | macsource |tcpdestport | tcpsourceport | udpdestport |
udpsourceport} data [mask mask] [vlan vlan] [cos cos] | [drop | forward]
Parameters
The following parameters apply to creating an admin rule.
The following parameters apply to creating a classification rule.
Note: Classification rules are automatically enabled when created.
admin‐profile Specifies that this is an admin rule for policy ID 0.
vlantag data Classifies based on VLAN tag specified by data. Value of data can range
from 1 to 4094 or 0xFFF.
mask mask (Optional) Specifies the number of significant bits to match, dependent
on the data value entered. Value of mask can range from 1 to 12.
Refer to Table 9‐35 for valid values for each classification type and data
value.
admin‐pid
profile‐index Associates this admin rule with a policy profile, identified by its index
number. Policy profiles are configured with the set policy profile
command as described in “
set policy profile ” on page 9‐4.
Valid profile‐index values are 1‐ 255.
port‐string port‐string (Optional) Assigns this rule to the specified policy profile on specific
ingress port(s). Rule would not be used until policy is assigned to the
specified port(s) using the set policy port command as described in “
set
policy port ” on page 9‐14.
profile‐index Specifies a policy profile number to which this rule will be assigned.
Policy profiles are configured with the set policy profile command as
described in “
set policy profile ” on page 9‐4. Valid profile‐index values are
1‐ 255.
ether Classifies based on type field in Ethernet II packet.
ipproto Classifies based on Protocol field in IP packet.
ipdestsocket Classifies based on destination IP address with optional post‐fixed port.
ipsourcesocket Classifies based on source IP address, with optional post‐fixed port.
iptos Classifies based on Type of Service field in IP packet.
macdest Classifies based on MAC destination address.