Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 221)

set spantree spanguardtrapenable
D-Series CLI Reference 6-29
Syntax
show spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the state of the SpanGuard trap function:
D2(ro)->show spantree spanguardtrapenable
Spanguard SNMP traps are enabled
set spantree spanguardtrapenable
Use this command to enable or disable the sending of an SNMP trap message when SpanGuard
has locked a port.
Syntax
set spantree spanguardtrapenable {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable the SpanGuard trap function:
D2(su)->set spantree spanguardtrapenable disable
clear spantree spanguardtrapenable
Use this command to reset the Spanning Tree SpanGuard trap function back to the default state of
enabled.
Syntax
clear spantree spanguardtrapenable
disable | enable Disables or enables sending SpanGuard traps. By default, sending traps
is enabled.