Hitachi L2002 - Manual (Page 49)

L200
2
Inverter
In
v
e
rt
er Mounting
and Installation
2–3
Front Housing Cover
HIGH VOLTAGE: Hazard of electrical shock. Disconnect incoming power before
working on this control. Wait five (5) minutes before removing the front cover.
To remove the cover, follow the steps below (applies to all inverter models):
1. Press downward on the cover at the two areas indicated to release the retaining tabs.
2. Slide the cover forward and away from the keypad until the top edge of the cover
reaches the notch in the inverter chassis.
3. Lift the cover upward to remove it.
To install the cover, follow the steps below (applies to all inverter models):
1. Align the tabs on the front housing cover with the notch on each edge of the inverter
chassis. Then lower the cover into position.
2. Slide the cover toward the keypad, keeping it flush against the inverter chassis.
Continue until the cover latches into place.
Notch on
inverter chassis
Tab