Teledyne 9110TH - Nitrogen Oxides Analyzer - Manual (Page 128)

Model 9110TH NOx Analyzer Operating Instructions
Teledyne Analytical Instruments 108
To access and navigate the VARS menu, use the following touch screen button
sequence:
SETUP X.X 7) CLOCK_ADJ=0 Sec/Day
+ 0 0
ENTR EXIT
SETUP X.X 6) CONC_PRECUISION : 3
AUTO 0 1 2 3 4 ENTR EXIT
SETUP X.X 6) CONC_PRECUISION : 1
PREV NEXT JUMP EDIT PRNT EXIT
Toggle these keys to change setting
SETUP X.X 2 ) STABIL GAS =NOX
NO NO
2
NOX O2 ENTR EXIT
SETUP X.X 2 ) STABIL_GAS=NOX
PREV NEXT JUMP EDIT PRNT EXIT
Choose Gas
SETUP X.X 1 ) MEASURE_MODE=NOX-NO
NEXT JUMP EDIT PRNT EXIT
SAMPLE RANGE = 500.0 PPB NOX=X.X
< TST TST > CAL SETUP
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X 0 ) DAS_HOLD_OFF=15.0 Minutes
NEXT JUMP EDIT PRNT EXIT
SETUP X.X 3 ) TPC_ENABLE=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X ENTER VARS PASS: 818
8 1 8 ENTR EXIT
SETUP X.X 0) DAS_HOLD_OFF=15.0 Minutes
1 5 .0 ENTR EXIT
SETUP X.X 7) CLOCK_ADJ=0 Sec/Day
PREV NEXT JUMP EDIT PRNT EXIT
EXIT ignores the new setting.
ENTR accepts the new setting.
SETUP X.X 3 ) TPC_ENABLE=ON
ON ENTR EXIT
SETUP X.X 4 ) DYN_ZERO=ON
PREV NEXT JUMP EDIT PRNT EXIT SETUP X.X 4 ) DYN_ZERO=ON
ON ENTR EXIT
Toggle this keys to change setting
Toggle this keys to change setting SETUP X.X 5) DYN_SPAN=ON
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 5 ) DYN_SPAN=ON
ON ENTR EXIT
Toggle this keys to change setting
Toggle this keys to change setting
Toggle to change setting
See Section 6.12.1. for
information on setting the
MEASRUE MODE