Teledyne 9110TH - Nitrogen Oxides Analyzer - Manual (Page 90)

Model 9110TH NOx Analyzer Operating Instructions
Teledyne Analytical Instruments 70
4.7.2.4. Editing DAS Parameters
Data channels can be edited individually from the front panel without affecting other
data channels. However, when editing a data channel, such as during adding, deleting or
editing parameters, all data for that particular channel will be lost, because the DAS can
store only data of one format (number of parameter columns etc.) for any given channel.
In addition, an DAS configuration can only be uploaded remotely as an entire set of
channels. Hence, remote update of the DAS will always delete all current channels and
stored data.
To modify, add or delete a parameter, follow the instruction shown in section 4.7.2.2
then press:
Edit Data Parameter Menu
Edit Data Channel Menu
SETUP X.X 0) CONC: ATIMER, 8, 800
PREV NEXT INS DEL EDIT PRNT EXIT
From the DATA ACQUISITION menu
(see Section 6.7.2.2)
Exits to the main
Data Acquisition
menu
SETUP X.X NAME:CONC
<SET SET> EDIT PRINT EXIT
SETUP X.X PARAMETERS: 8
<SET SET> EDIT PRINT EXIT
SETUP X.X 0) PARAM=DETREP, MODE=INST
PREV NEXT INS DEL EDIT EXIT
Press SET> key until…
SETUP X.X EDIT PARAMS (DELETE DATA)
YES NO NO returns to
the previous
menu and
retains all data.
Moves the
display between
available
Parameters
Inserts a new Parameter
before the currently
displayed Parameter
Deletes the Parameter
currently displayed.
Use to configure
the functions for
this Parameter.
Exits to the main
Data Acquisition
menu
YES will delete
all data in that
entire channel.