Rockwell Automation 1326 Digital AC Multi-Axis Motion Control System User Manual - Manual (Page 159)

Publication 1394-5.0 — May 2000
Configuring Your 1394 Analog Servo System 8-23
[Sys Mod Data]
Diagnostic information of data communicated
between the controller and system module.
Parameter Numbers 6
Parameter Group Linear List
Parameter Type Read Only
[Sys Mod Status 2]
Diagnostic information of smart power systems.
Active on all Smart Power 22 kW systems and 5
and 10 kW (Series C or later) systems
1 = true
Note: Warnings are set at 80% rating.
Parameter Numbers 38
Parameter Group Linear List
Parameter Type Read Only
[System Type]
Catalog number of System Module. Set during
the initialization of the 1394
x-SJTxx-A system
module.
Parameter Numbers 14
Parameter Group Configuration
Display Units None
Parameter Type Read Only
Linkable No
0 "NOT PRESENT"
1 "1394 x-SJT05"
2 "1394 x-SJT10"
3 "1394-SJT22"
[Test Mode Sel]
Internal (factory) test mode selections.
Parameter Numbers 16
Parameter Group Linear List
Display Units None
Parameter Type Read/Write
Change While Running Yes
Linkable No
Minimum Value 0
Maximum Value 32767
Default Value 0
Bit 15 Bit 14 Bit 13 Bit 12 Bit 11 Bit 10 Bit 9 Bit 8 Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Version Bits
Ctrl Pwr Loss
Ovr Temp Flt
Bus Undr Vlt
Bus 0V Flt
Phs Loss Flt
Ground Fault Size Bit
Not Used
Size Bit
Size Bit
Size Bit
Bit 15 Bit 14 Bit 13 Bit 12 Bit 11 Bit 10 Bit 9 Bit 8 Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
CurLim Fault
Shunt Warn
Ctrl Pwr Loss
Ovr Temp Flt
Bus Undr Vlt
Bus 0V Fault
Phs Loss Flt
Ground Fault
Shunt Fault
CurLim Warn
Not Used
PreCharge Fault