Placing the him in the him cradle – Rockwell Automation 1326 Digital AC Multi-Axis Motion Control System User Manual User Manual
Page 278
Advertising
Publication 1394-5.0 — May 2000
C-16
Using the Human Interface Module (HIM)
Placing the HIM in the HIM Cradle
To put the HIM in the HIM cradle:
1. If it’s not already connected, connect the SCANport cable to the
HIM.
2. With the keypad facing you, slide the top of the HIM up into the
HIM cradle and push the bottom end of the HIM into the cradle
until the tabs latch the HIM. The tabs lock the HIM into place.
Advertising
This manual is related to the following products: