Rockwell Automation 1326 Digital AC Multi-Axis Motion Control System User Manual User Manual
Page 196
Advertising
Publication 1394-5.0 — May 2000
9-30
Troubleshooting
6. Unplug the fan housing from the axis module.
7. Locate the fan gasket that is attached to the fan housing.
Figure 9.13
Locating the Fan Gasket
8. Remove the fan gasket from the fan housing. Make sure you slide
the fan wires through the slit in the gasket.
9. Remove the screws and nuts that hold the fan to the fan housing.
Figure 9.14
Removing Fan Screws and Nuts
10. Remove the fan from the fan housing.
Fan Gasket
Slit
Advertising
This manual is related to the following products: