Rockwell Automation 1326 Digital AC Multi-Axis Motion Control System User Manual - Manual (Page 84)

Publication 1394-5.0 — May 2000
4-4 Wiring 1394 GMC and GMC Turbo Systems
Using the Terminal Operating Tool to Insert Wires
Each system module you order comes with a terminal operating tool
that allows you to easily insert your wires into the terminals. Refer to
Appendix D for the part number.
Figure 4.3
Terminal Operating Tool
To use the terminal operating tool with TB1:
1. Put the hook into the hook slot with tab end of the tool to your
left.
2. Gently push the tool to the right to open the wire slot.
3. Insert the wire.
4. Gently release the tool by moving it to the left.
5. Reverse directions for TB2.
Flat tab
Hook
Insert wire
here