Rockwell Automation 1326 Digital AC Multi-Axis Motion Control System User Manual - Manual (Page 268)

Publication 1394-5.0 — May 2000
C-6 Using the Human Interface Module (HIM)
Search Mode
Search mode allows you to search for established links or modifiable
parameters that are not at their default values.
Control Status Mode
Control Status enables or disables HIM control and provides access to
a fault and warning queue, which lists the last eight faults that have
occurred. If the word “Trip” appears with a fault, that fault actually
tripped the drive. To clear the queue, use the clear function.
Password
The Password menu has three choices. The Password Login menu is
used to enable programming by entering the correct password. The
default password is 0, which disables the password function. The
Password Modify menu allows you to change the password. The
password 1201 is permanently embedded in the system and can be
used to override the current password. Finally, the Password Logout
menu is used to logout of the programming mode.
Linking Parameters
Linking creates a connection between two parameters so that
information can be passed to or from another device. The source
parameter is the parameter from which the information is coming, and
the destination parameter is the location into which the information
will be put. For example, you might choose to link axis parameter 220
Vel Command (speed) to analog output 1 to provide an analog voltage
signal to a chart recorder.
Note: You cannot change linked parameters while the system is
running.
To link parameters:
Note: These steps assume that you are starting from the top level of
the HIM (Sys Wait Bus).
1. At the HIM, press ENTER. A message similar to the following
appears:
2. Press either the up or down arrow key until the following appears:
3. Press ENTER. The system records your choice and the following
message appears:
Choose Mode
Display
Choose Mode
Link
Link
Set Links