Rockwell Automation 1326 Digital AC Multi-Axis Motion Control System User Manual - Manual (Page 269)

Publication 1394-5.0 — May 2000
Using the Human Interface Module (HIM) C-7
4. Press ENTER. The system records your choice, scans for
linkable parameters, and a message similar to the following
appears:
5. The number on the left is the destination and the number on the
right is the source.
6. Press either the up or down arrow key until the parameter in
which you want to store the linked value appears.
7. Press SEL. The cursor moves to the source parameter.
8. Press either the up or down arrow key until the parameter from
which you will get the linked value appears.
9. Press ENTER. The system records your choice and the cursor
moves to the destination value.
10. Press ESC. The following appears:
11. Press ESC. The following appears:
12. Press either the up or down arrow key until the following appears:
13. Press ENTER. The system records your choice and the following
message appears:
14. Press ENTER. The system saves the values that you entered and
the following message appears:
Using Copy Cat
Copy Cat is an optional (Series B HIM only) file upload/download
utility that copies the information from one drive and stores it in the
HIM so that you can make a duplicate of it to place in another system
or create a backup of a system’s information. It copies parameters and
links and pastes all the read/write parameters and links to another
drive. You can store copies of up to two different systems in the HIM
at one time.
D/A # 1 Value
<12> <--- 232>
Link
Set Links
Choose Mode
Link
Choose Mode
EEPROM
EEPROM
Save Values
Choose Mode
EEPROM