Rockwell Automation 1326 Digital AC Multi-Axis Motion Control System User Manual - Manual (Page 187)

Publication 1394-5.0 — May 2000
Troubleshooting 9-21
4.
5. Open the system module door.
6.
Important: To avoid damaging the wires, miswiring the input
wiring board, and potential damage to the system,
only replace the input wiring board when replacing a
system module of a different series (refer to the table
above).
Note: To determine the series of your module, refer to Figure P.1
in the Preface.
If you removed a: Do this:
Analog Servo system
module with a HIM
module mounted in the
door 1. Remove the HIM or cover plate
from the new system module.
2. Install the HIM module you
removed from your existing drive
into the door of your replacement
system module.
3. Open the system module door.
4. Plug the SCANport cable from
the drive in the top of the HIM
module.
5. Go to main step 6.
Analog Servo system
module without a HIM
module mounted in the
door Go to main step 5.
GMC, GMC Turbo, or
CNC, system module Go to main step 5.
If your old system
module is: And your new
system module is:
Do this:
Series A and B Series A and B Go to Replacing
System Modules of
the Same Series.
Series A and B Series C Go to Replacing
System Modules of a
Different Series.
Series C Series C Go to Replacing
System Modules of
the Same Series.
Series C Series A and B Go to Replacing
System Modules of a
Different Series.