Metrohm viva 1.1 - Manual (Page 130)

3.6 Run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
118 ￭￭￭￭￭￭￭￭
viva 1.1
3.6.3 Single determination
3.6.3.1 Single determination - Overview
Tab: Workplace ▶ Run ▶ Single determination
Parameters and sample data for single determinations can be edited and
run functions can be triggered on the Single determination tab. It con-
tains the following elements and functions:
￭ Single determination - Controls
Buttons for starting, stopping, interrupting and resuming determina-
tions.
￭ Single determination - Status display
Shows the current status of the workplace.
￭ Single determination - Determination parameters
Entry of general parameters for the determination.
￭ Single determination - Sample data
Entry of method and sample identification for the next determination.
￭ Properties - Single determination
Definition of the properties for the Single determination tab.
3.6.3.2 Single determination - Controls
Tab: Workplace ▶ Run ▶ Single determination
The following controls are located on the Single determination tab:
Starting a single determination (shortcut: Ctrl G)
This button is present in the status READY (no determination started). If
the start can be triggered, then it will be green, otherwise light gray.
Stopping a single determination (shortcut: Ctrl S)
The button is present in the status BUSY (determination is running).