Metrohm viva 1.1 - Manual (Page 482)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
470 ￭￭￭￭￭￭￭￭
viva 1.1
'Name of the dosing unit'
Alphabetically organized selection of the names of the dosing units
from the table of dosing units in the configuration. A check is made
prior to the start of a method to determine whether the selected dos-
ing unit is identical with the name of the dosing unit at the selected
MSB connector.
not defined
No check is made prior to the start of a method to determine whether
the selected dosing unit is identical with the name of the dosing unit at
the selected MSB connector. This has the advantage that a method can
be utilized by users who use other dosing units.
5.5.2.4.8 EMPTY
5.5.2.4.8.1 EMPTY - Overview
Dialog window: Method ▶ EMPTY ▶ Properties... ▶ EMPTY - 'Command name'
Command for emptying the cylinder and tubings of a dosing unit.
Instruments
This command can be executed with the following instruments:
Voltammetry: 894
Dosing Interface: 846
Sample changer: 814, 815, 858, 919
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the EMPTY command are configured in the following
dialog window:
￭ EMPTY - Properties
Command variables
The following command variables are generated by the EMPTY com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':