Metrohm viva 1.1 - Manual (Page 963)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.1
￭￭￭￭￭￭￭￭ 951
7.11.6.1 Properties Stepping motor
Dialog window Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'De-
vice type' - 'Device name' ▶ Stepping motors ▶ [Edit] ▶ Properties stepping
motor
The properties of the individual stepping motors are set on the Proper-
ties stepping motor dialog window.
Port
Shows the internal designation for a stepping motor of the type Dig-
Out_x_y_z, where x stands for the controller, y for the digital output ter-
minal and z for the output on this terminal.
Port description
Freely selectable designation for a stepping motor port. This designation is
used in the program to actuate the port.
Entry 50 characters
Default value DigOut_x_y_z
The following characters must not be part of the
port designation: \, ', ., {, }, [, ].
Type
Selection of the port type.
Selection Linear drive | Rotary drive
Default value Linear drive
Default values for commands
Action
Action which the stepping motor is to perform.
Selection 'empty' | Reference position | Relative posi-
tion | Absolute position | End position | Reset
Default value 'empty'
Reference position
Move to reference position of stepping motor.
Relative position
Go to a relative position; in this case, the stepping motor moves by the
value defined by Distance/Angle in relation to the current position.
Absolute position
Move to an absolute position; in this case, the stepping motor moves
to the value defined by Distance/Angle.
End position
Move to final position of the stepping motor.