Metrohm viva 1.1 - Manual (Page 304)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
292 ￭￭￭￭￭￭￭￭
viva 1.1
Jump to the next determination.
Jump to the last determination.
4.5.2.5.5.2 Result view - Curves
Subwindow: Database ▶ Determination overview ▶ Determinations ▶ Repro-
cess... ▶ Reprocessing ▶ Curves
The curves of the selected determination are displayed on the Curves tab.
A tab with the corresponding command name is present for each run of a
measuring command; their sequence is determined by the method.
4.5.2.5.5.2.1 Voltammetry commands curve display
Tabs
In the curve window, a tab with the corresponding command name is
provided for each run of a voltammetry command. Their sequence is
determined by the method. The upper part of these tabs shows the
recorded voltammograms or calibration curves and the lower part con-
tains information on the individual measurement curves. The
symbols
serve to maximize either the upper or the lower part to the size of the
entire curve window or reset it again.
An icon representing the type of displayed curves is located next to the
title of the tab. You can toggle between the types by clicking on this icon.
Shows the measurement curve (see Chapter 4.6.1.2.1, page
330).
Shows the calibration curve (see Chapter 4.6.1.2.2, page 332).
4.5.2.5.5.2.1.1 Measurement curve
Tab: Database ▶ Determination overview ▶ Determinations ▶ Repro-
cess... ▶ Reprocess ▶ Result view ▶ Curves
Displaying the measurement curve
The following elements are displayed in the upper part of the curve win-
dow:
￭ Axes with labeling (measured quantity and unit)
￭ Measuring point curves
￭ Peak label with substance name
￭ Baselines
￭ Base points