Metrohm viva 1.1 - Manual (Page 298)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
286 ￭￭￭￭￭￭￭￭
viva 1.1
￭ Monitoring
If the method contains monitoring of variables, then the corresponding
messages will be displayed and included in the report, but no e-mails
will be sent and no beep will be generated. If one of the two actions
Cancel determination or Cancel determination and series is acti-
vated, then recalculation will be canceled.
￭ Voltammetry commands and measuring commands
For voltammetry and measuring commands that can be evaluated, only
the evaluations for which data is present will be recalculated. All other
parameters will be ignored.
￭ Conditional CALL commands
In the case of a conditional CALL command, the track that was run
through originally will always be called.
￭ Waiting times and timeout times
All waiting times and timeout times of commands are set to 0 for
recalculation.
￭ Non-executed commands
The commands REQUEST, WAIT, RECEIVE, SEND, TRANSFER,
STIR, SCAN, CTRL, MOVE, SWING, LIFT, PUMP, RACK, HEATER,
ADD AUX, ADD STD, ADD SAMPLE, ADD SAMPLE DT, LQH,
PREP and EMPTY are run through but no longer performed.
Modified volumes for manual addition in ADD commands are now
applied during recalculation.
￭ Reports
The reports defined in the method are generated, but the defined out-
put targets are ignored. A report can only be correctly generated dur-
ing reprocessing if the defined report template has already been used
in the regular determination run. If the required report template is not
present in the original determination, a message entry is made, the
report is skipped and reprocessing is continued.