Metrohm viva 1.1 - Manual (Page 887)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.1
￭￭￭￭￭￭￭￭ 875
Rinse position
Rinse position that is valid for all four external positions and which can be
approached with the LIFT command.
Input range 0 - 235 mm
Default value 0 mm
[Configuration]
Opens the Robotic arm configuration dialog window (see Chapter
7.3.8, page 859), in which the properties of the robotic arm can be
edited.
Table for external positions
The properties for the four possible external positions for the robotic arm
mounted on the Swing Head are shown in the table. The table cannot be
edited directly.
External position
Number of the external position.
Angle [°]
Swing angle for external position.
Work position [mm]
Work position for external position.
[Edit]
Opens the External position # dialog window (see Chapter 7.3.9, page
860), in which the parameters for the external position selected from the
table can be edited.
7.5.4 Properties - Rack
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Rack
The Rack tab shows the rack-specific data of the attached rack.
Rack name
Shows the name of the rack attached. If no rack is attached, then "-----" is
shown.
Rack code
Shows the rack code of the rack attached. The rack code corresponds to
the arrangement of magnets on the base of the rack and is read in by the
Sample Processor in order to recognize the rack. If no rack is in position,
then the display will be empty.