Metrohm viva 1.1 - Manual (Page 664)

5.6 Evaluation subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
652 ￭￭￭￭￭￭￭￭
viva 1.1
NOTE
The parameter Reversed peaks is disabled in the CP command,
because there is no peak evaluation for the CP command.
5.6.2.3 General - Curve evaluation
Tab: Method ▶ Evaluation ▶ General ▶ Curve evaluation
Fixed point evaluation
on | off (Default value: off)
If this check box is activated, then the associated values for the other
measured quantities will be interpolated with a fixed measured quantity
(or an independent variable) for the fixed point from the measuring point
list. These values can then be accessed via the formula editor and be out-
put as user-defined results.
Table
NOTE
The table has ten lines at most.
The table on the Curve evaluation tab contains an overview of the
parameters defining the fixed point evaluation. The table contains the fol-
lowing columns:
FP
Number of the fixed point for the assignment of the fixed point F {z} in the
result variables in the formula editor (see Chapter 2.3, page 21).
Measured quantity
Measured quantity (or independent variable) to which the associated val-
ues for the other quantities will be interpolated from the measuring point
list.
Fixed value
Fixed value of the corresponding number of the selected line in the table.
Unit
Unit of the measured quantity (or the independent variable).