Metrohm viva 1.1 - Manual (Page 669)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1
￭￭￭￭￭￭￭￭ 657
Modifies the sequence of shown substances by moving the selected line
downward.
Edit menu
New... Selects the empty line marked with the asterisk and opens the Substance -
Recognition dialog window (see Chapter 5.6.3.3, page 657).
Properties... Edit the selected line (see Chapter 5.6.3.3, page 657).
Copy Copies the selected lines to the clipboard.
Paste Inserts all lines from the clipboard above the line marked with the asterisk.
Cut Copies the selected lines to the clipboard and deletes them.
Delete Deletes the selected lines.
5.6.3.3 Editing recognition
Dialog window: Method ▶ Evaluation ▶ Substances ▶ Recogni-
tion ▶ [Edit] ▶ New... / Properties... ▶ Substance - Recognition
Measuring command
Shows the measuring command for which the substances can be defined.
Substance
Name of the substance that must be unambiguous within the same table
for each measuring command. The same substance name can however
also be used for a different measuring command.
Entry 1 - 50 characters
Default value 'empty'
Active
on | off (Default value: on)
If this check box is activated, then this substance will be evaluated; if it is
deactivated, then no evaluation will take place. Parameter data from inac-
tive substances will also continue to be listed in other tables, but have no
effect on the determination.
Potential step
Selection of the potential steps (plating potential and stripping potentials)
defined in the CPVS command (see Chapter 5.5.2.11.3.4, page 636).