Metrohm viva 1.1 - Manual (Page 432)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
420 ￭￭￭￭￭￭￭￭
viva 1.1
Entry 25 characters
Call text
Freely editable text for the designation of the call; the text is displayed in
the command depiction.
Entry 50 characters
Default value 'empty'
Track name
Selection of the VA track to be called up. All of the VA tracks available in
the method are displayed.
Selection 'Track name'
Stop criteria
Definition of four possible criteria for the cancellation of the command
call. The stop criterion that is reached first applies for the cancellation. If
not stop criterion is switched on, then the action will not be carried out.
Evaluation quantity
on | off (Default value: on)
If this check box is activated, then the call of the VA track will no longer
be carried out if the standard deviation of the evaluation quantity for the
selected substance falls below the specified value.
If the calibration method no calibration has been selected, then the
standard deviation will be automatically calculated with the area of the
selected substance.
VA measuring command
Selection of the VA measuring command whose evaluation quantity is to
be checked.
Selection 'VA measuring command'
Substance
Selection of the substance for which the evaluation quantity is to be
checked.
Selection 'Substance'
Standard deviation
Specification of the standard deviation of the evaluation quantity for the
selected substance. If this value is not achieved, then the VA track will no
longer be called again. All of the measuring results of the VA measuring
command are used for the calculation of the standard deviation that were