Metrohm viva 1.1 - Manual (Page 916)

7.9 Barcode reader
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
904 ￭￭￭￭￭￭￭￭
viva 1.1
7.9.4 Properties - Settings
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Settings
Barcode reader ID
Shows the identification of the barcode reader.
Input target
Selection of the field into which the barcode reader input is to be entered.
Selection Active input field | Method | Sample type |
Sample position | Sample amount | Sample
amount unit | ID1...ID16 | Analytical volume |
Dilution volume
Default value Active input field
[Connect]
Establishes a connection with the barcode reader. The Establish connec-
tion dialog window appears (see Chapter 7.9.6, page 906).
[Disconnect]
Disconnects the connection with the barcode reader (only then can the
device be deleted from the configuration).
7.9.5 Properties - GLP
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ GLP
Tab: Configuration ▶ Dosing units ▶ [Edit] ▶ Properties... ▶ Dosing unit - 'Na-
me' ▶ GLP
Tab: Configuration ▶ Solutions ▶ [Edit] ▶ Properties... ▶ Solution - 'Name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in
the Select date dialog window (see Chapter 2.4.1, page 77).
Comment on GLP test
Comment regarding the GLP test.
Entry 1,000 characters
Monitoring of GLP validity
on | off (Default value: off)
If this check box is activated, then the time interval for the GLP test is
monitored.