Metrohm viva 1.1 - Manual (Page 903)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.1
￭￭￭￭￭￭￭￭ 891
FPGA version
Shows the FPGA version of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Remarks
Remarks about the device.
Entry 1,000 characters
Default value 'empty'
7.7.3 Properties - Settings
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Settings
Light source
Wavelength
Wavelength which has been set on the Photometer. If a value is defined
here, a check is performed for each command containing a specified
wavelength whether the wavelength specified in the command corre-
sponds with the wavelength defined here for the device.
Input range 100 - 2,000 nm
Selection 'empty'
Default value 'empty'
Light source always active
on | off (Default value: on)
If this check box is activated, then the LED on the Photometer is always
on. Otherwise, the firmware will switch it on before the measurement and
switch it off after the measurement.
Heater
Initial temperature
Initial temperature of the device (temperature of the cuvette). Entering an
initial temperature means that the heater will heat up to the set tempera-
ture when the device is switched on. off means that the heater will not be
switched on.
Input range 20 - 60 °C
Default value 30 °C
Selection off