Metrohm viva 1.1 - Manual (Page 142)

3.6 Run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
130 ￭￭￭￭￭￭￭￭
viva 1.1
Start series (shortcut: Ctrl G)
Start of the first determination of a sample series. The button is disabled
as soon as the first determination begins running. If the start can be trig-
gered, then it will be green, otherwise light gray.
Stop series (shortcut: Ctrl S)
Immediate stop of the ongoing determination of a sample series. The but-
ton is enabled as soon as the first determination begins running. If the
stop can be triggered, then it will be red, otherwise light gray.
Interrupt run
Interrupts the ongoing determination of a sample series. The button is
enabled (dark gray) in the status BUSY (determination is running). The
button is disabled (light gray) in all other cases. When [Hold] is pressed,
this button will be replaced in the display by [Cont].
However, [Hold] does not allow you to stop all partial steps of a voltam-
metry command (see Chapter 5.5.2.11.1, page 606).
Continue run
Continues the ongoing determination of a sample series. The button is
only present in the status HOLD (determination interrupted). When you
click on [Cont], then this button will be replaced again in the display by
[Hold].