Reservoir functions – Bio-Rad Bio-Plex Software® Upgrades and Conversions User Manual
Page 114
Bio-Plex Manager Software 6.1 User Guide | Running Protocols
102
Reservoir Functions
The Bio-Plex Manager
™
6.1 software reservoir functions allow you to
incorporate standard maintenance processes directly into the Run Protocol.
This enables you to perform the Run Protocol without needing to replace the
microplate with the MCV plate. The maintenance processes you can select
with the Reservoir Functions window are:
•
Wash
•
Wash between plates
•
Prime
•
Drain
•
Back flush
•
Sanitize
•
Alcohol wash
•
Start up
•
Shut down
•
Remove bubbles
NOTE: Two of the most common functions users want performed
after the plate is run are Shut Down and Wash Between Plates.
For users’ convenience, these functions can also be selected
directly from the Run Protocol window.
These functions are available to the Protocol before the run and after the run.
When running the Protocol, the status bar indicates which function is in
process.
Figure 94. Reservoir Functions dialog
BioPlex_6.book Page 102 Friday, September 23, 2011 11:55 AM