Bio-Rad Bio-Plex Software® Upgrades and Conversions - Manual (Page 131)

Raw Data Table
119
Raw Data Table
The Raw Data table displays the raw numerical data of a reading, as well as all
instrument settings and information related to the system hardware and
software used in the reading (version numbers, voltage, temperature, gain,
etc.).
NOTE: The instrument hardware and software information included in the Run
Info window of previous Bio-Plex Manager versions is now provided in the
Raw Data table.
This table is available in both the Run Protocol window and in the Raw Data
window of the Results file. (Note that you can only print and export the Raw
Data table from a Results file, not a Protocol window.
The first few lines of this table are visible below the bead map and histogram.
Alternatively, hide the histogram/bead map display by clicking on the Show/
Hide Histogram/Bead Map button to maximize the table.
Figure 107. Raw data from a reading
During a reading, the table is filled in line by line as each well is read. After the
reading is complete, all the data are displayed.
In the table, the fluorescence intensities (FI) of the analytes you selected are
listed for each well number.
NOTE: During a reading, the array reader always detects all the analytes in the
sample, including any that you have not selected. However, analytes that were
not selected in the Protocol are not included in the table, even if they were
detected. After a reading, you can go back and change your selections under
Select Analytes, and the new analytes, if detected, will appear in the table.
For online Help information about the Raw Data table, click the Display Help
for Table Legend button .
BioPlex_6.book Page 119 Friday, September 23, 2011 11:55 AM