Bio-Rad Bio-Plex Software® Upgrades and Conversions User Manual
Page 73
Protocol Window
61
Each analyte is listed by name and region number. The region number refers
to the region of a fluorescent color map used to identify the analyte's bead
set. Each bead set is embedded with specific quantities of two fluorescent
dyes; the combination of these fluorochromes, as detected by the array
reader, places the bead set within a unique region on the color map, thereby
identifying the set and its associated analyte.
To move an individual analyte into the Selected list, double-click it. Double-
click an analyte in the Selected list to move it back.
Hold down the Shift or Ctrl key and click multiple analytes in the Available list
to select them as a group. Then click the Add >> button to move them over to
the Selected list. Use the << Remove button to return multiple selected
analytes back to the Available list.
Use Add All>> to move all the available analytes into the Selected list, and
<<Remove All to move them back.
Figure 42. Selecting the analytes to be reported
NOTE: Some analytes share the same region. Only one analyte per region can
be added to the Selected list.
C
USTOMIZING
A
NALYTES
AND
P
ANELS
Bio-Plex Manager comes preconfigured with a selection of panels and
analytes that Bio-Rad provides as Bio-Plex assays. You can edit these and/or
create new ones.
NOTE: If you have assay kits for analytes that are not included in Bio-Plex
Manager, you must add these analytes using the commands described in this
section.
BioPlex_6.book Page 61 Friday, September 23, 2011 11:55 AM