Bio-Rad Bio-Plex Software® Upgrades and Conversions - Manual (Page 4)

Bio-Plex Manager Software 6.1 User Guide
ii
B IO -R AD T ECHNICAL S UPPORT D EPARTMENT
The Bio-Rad Technical Support Department in the U.S. is open Monday through Friday,
5:00 a.m. to 5:00 p.m., Pacific Standard Time. Worldwide technical support is available on
the Web at
www.consult.bio-rad.com .
Phone: 1-800-424-6723, option 2
Fax: 1-510-741-5802
Email: [email protected] (U.S.)
[email protected] (International)
Web: www.consult.bio-rad.com
N OTICE
No part of this publication may be reproduced or transmitted in any form or by any means,
electronic or mechanical, including photocopy, recording, or any information storage or
retrieval system, without permission in writing from Bio-Rad.
Bio-Rad reserves the right to modify its products and services at any time. This user guide
is subject to change without notice. Although prepared to ensure accuracy, Bio-Rad
assumes no liability for errors or omissions, or for any damage resulting from the
application or use of this information.
The following are trademarks of Bio-Rad Laboratories: Bio-Rad, Bio-Plex, and Bio-Plex
Manager. Luminex, xMAP, and xPONENT are trademarks of Luminex Corporation.
Windows is a trademark of Microsoft Corporation. Pentium is a trademark of Intel
Corporation.
No rights or licenses under any of Luminex Corporation’s patents are granted by or shall
be implied from the sale or acquisition of this Bio-Plex system containing Luminex
technology (the “System”) to you, the end-user. By using this System, you agree that (i) the
System is sold only for use with fluorescently labeled microsphere beads authorized by
Luminex (“Beads”), and (ii) you obtain rights under Luminex’s patents to use this System
by registering this System with Bio-Rad in accordance with the instructions accompanying
this System and by Bio-Plex Manager Software 6.1 User Guidepurchasing a kit containing
Beads.
Copyright © 2001–2011 by Bio-Rad Laboratories. All rights reserved.
BioPlex_6.book Page ii Friday, September 23, 2011 11:55 AM