HP R4.2 - Manual (Page 146)

3
Voice System Administration Voice Equipment
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 107
The system displays the Change State of Voice Equipment window
(
Figure 65 ).
Figure 65. Change State of Voice Equipment Window
2 Enter the state to which the designated equipment should be changed in
the
New State: field or press F 2 (Choices) to select from a menu. Valid
choices are inserv (in service) and manoos (manual out–of–service).
3 Enter channel or card for the type of equipment in the Equipment: field,
or press F 2 (Choices) to select from a menu.
4 Enter the equipment number or numbers for which you want to change
the state in the
Equipment Number: field. Type a single number, a range
of numbers separated by commas or spaces, or all (default).
5 (Optional) Enter Yes or No in the Change Immediately: field. If you
enter Yes, active calls on the specified equipment are disconnected
abruptly. If you enter No, the state is changed after all current calls end.
The changes might not be displayed immediately if you use the No value.
If you leave this field blank, the No value is used as the default.