Change t1 a/b robbed-bit e&m parameters – HP R4.2 User Manual
Page 196
4
Switch Interface Administration
Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507
Issue 3 April 2000 157
15
Ignore the last two fields:
Idle Code:
and
A-LAW or MU-LAW:
.
16
Press
F 3
(Save).
The system assigns the protocol to the selected circuit card.
Change T1 A/B
Robbed-bit E&M
Parameters
The circuit card must first be assigned to the T1 A/B Robbed-bit E&M
protocol to use this procedure. See
Assigning T1 A/B Robbed-bit E&M to
Digital Circuit Cards on page 151
for more information about making the
initial assignment.
Note:
Before attempting to make any assignment changes to circuit
cards, they must be in the MANOOS state. See
on page 103
in
Chapter 3, Voice System Administration
, for
additional information.
If you change digital protocol assignments on the voice system,
you must also make the change on the switch.
To change the T1 A/B Robbed-bit E&M parameters:
1
Start at the T1 A/B Robbed-bit E&M menu (
Figure 88 on page 151
) and
select:
> Change Parameters