HP R4.2 - Manual (Page 200)

4
Switch Interface Administration Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 161
The Card Number: field is blank in Figure 91 . After you enter the circuit
card number, certain E1-only fields disappear ( Idle Code: , A-LAW or
MU-LAW: , and CRC: ).
The system displays the parameter values for the selected circuit card.
3 Press F 6 (Cancel) to return to the T1 A/B Robbed-bit E&M menu.
Unassigning T1 A/B
Robbed-bit E&M to
Digital Circuit Cards Note: Before attempting to make any assignment changes to circuit
cards, they must be in the MANOOS state. See
Equipment State
on page 103 in Chapter 3, Voice System Administration , for
additional information.
If you also change digital protocol assignments on the voice
system, you must make the change on the switch.
To unassign the T1 A/B Robbed-bit E&M protocol to a digital circuit card:
1 Start at the T1 A/B Robbed-bit E&M menu ( Figure 88 on page 151 ) and
select:
> Unassign Card