Changing digital r2 mfc - mexico parameters – HP R4.2 User Manual
Page 207
4
Switch Interface Administration
Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507
Issue 3 April 2000 168
Changing Digital R2 MFC - Mexico Parameters
The E1 circuit card must first be assigned to the Digital R2 MFC - Mexico
protocol to use this procedure. See
Assigning the Digital R2 MFC - Mexico
Protocol to E1 Circuit Cards on page 164
for more information about making
the initial assignment.
Note:
Before attempting to make any assignment changes to circuit
cards, they must be in the “manoos” state. See
on page 103
in
Chapter 3, Voice System Administration
, for
additional information.
If you change digital protocol assignments on the voice system,
you must also make the change on the switch.
To change the Digital R2 MFC - Mexico parameters:
1
Start at the Digital R2 MFC Protocol - Mexico menu (
Figure 93 on page
164
) and select:
The system displays the Change Parameters: Digital R2 MFC Protocol -
Mexico window (
Figure 95 on page 169
).
> Change Parameters