HP R4.2 - Manual (Page 186)

4
Switch Interface Administration Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 147
Figure 87. Display Digital Interface Assignments
By default, a circuit card is marked unassigned . A protocol must be
installed on the voice system before it can be assigned to an E1/T1 card
(CWB2).
See “E1/T1 Circuit Cards,” in Chapter 2, “Installing or Replacing Circuit
Cards,” in UCS 1000 R4.2 Maintenance, 585-313-126, for more
information on configuring the CWB2.
Table 11 on page 148 shows the valid parameters and default values for the
E1/T1 digital protocols. The procedures in this section detail each protocol
and how to set the parameter values for each. Refer to this table as you set
the parameters for your protocol.