HP R4.2 - Manual (Page 656)

A
Summary of Commands vsenable
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 617
Example
vsdisable
See Also
vsenable
vsenable
The vsenable command enables the automatic starting of the voice system
at system reboot.
Synopsis
vsenable
Description
When the vsenable command is run, UNIX system files are modified to allow
the voice system to be automatically started when the system is rebooted. By
default, the voice system is installed with the automatic startup enabled. If
there were any nonfatal problems during installation, the voice system is still
installed but it has not been enabled for automatic startup at system reboot.
After the installation problems have been cleared, use vsenable
to enable
automatic voice system startup at reboot.