HP R4.2 - Manual (Page 228)

4
Switch Interface Administration Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 189
• Incoming/Outgoing Start Dialing: wink/wink
• Incoming/Outgoing Addressing: DTMF/DTMF
~ Timing Source: Looped Timed
• 4ESS Options
The following information is requested by AT&T when provisioning the
4ESS switch for an E1/T1 connection:
~ TYPE CPE: DIGITAL PBX/ACD (WITH DS1 INTERFACE)
• 4E NETWORK SWITCHED BASED SERVICES: MEG (Megacom),
MEG8 (Megacom 800), or MULTIQUEST* as desired
• ACCESS TYPE: T1
• TRUNK OPERATION: The voice system always allows two-way
traffic. If you expect only incoming calls, it is recommended that
you select 1W/IN TOWARDS CPE. If you expect only outgoing
calls, it is recommended that you select 1W/OUT FROM CPE. If
you expect two-way traffic, select 2WAY.
• SUPERVISION: EM
• ADDRESS SIGNALING (TYPE OF PULSING) TO CPE: DTMF(TT)
• ADDRESS SIGNALING TT DELAY: 70MS
• ADDRESS SIGNALING from CPE: DTMF(TT)