Displaying t1 a/b robbed-bit e&m parameters – HP R4.2 User Manual
Page 198
4
Switch Interface Administration
Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507
Issue 3 April 2000 159
The
Card Number:
Figure 90 on page 158
. After you enter
the circuit card number, certain E1-only fields disappear (
Idle Code:
,
A-
LAW or MU-LAW:
, and
CRC:
).
3
Change any of the parameters as described in
bit E&M to Digital Circuit Cards on page 151
.
4
Press
F 3
(Save).
The system changes the protocol parameters on the selected circuit card.
Displaying T1 A/B
Robbed-bit E&M
Parameters
The circuit card must first be assigned to the T1 A/B Robbed-bit E&M
protocol to use this procedure. See
Assigning T1 A/B Robbed-bit E&M to
Digital Circuit Cards on page 151
for more information about making the
initial assignment.
To display the T1 A/B Robbed-bit E&M parameters:
1
Start at the T1 A/B Robbed-bit E&M menu (
Figure 88 on page 151
) and
select:
> Display Parameters