HP R4.2 - Manual (Page 611)

A
Summary of Commands soft_szr
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 572
See Also
dip_int
soft_szr
The soft_szr command starts a script on a channel.
Synopsis
soft_szr <channelStart-channelEnd> <script>
Description
The soft_szr command can be used to start a script on a channel. The
soft_szr
command sends a message to TSM requesting that a script be
started on a channel. If the channel is in use, the script is not started.
Soft_szr waits for a response from TSM. When soft_szr
exits, TSM has
either accepted the request and started the script or rejected the request.
There are two arguments to the soft_szr command: <channel> and <script> .
The <channel> argument specifies the channel or range of channels on
which you want to start the script. The <script> argument specifies the script
to be started. The script does not have to be in the table of assigned scripts.
The channel number(s) must be valid and the channel(s) must not be busy,
and the channel(s) must be in the inserv state. If you specify a channel that is