HP R4.2 - Manual (Page 600)

A
Summary of Commands restore
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 561
T1 diagnostics are executing online tests and a conflict is detected, the
restore
command is blocked. If T1 diagnostics are executing offline tests
and a conflict is detected, the user is asked whether to wait until the
conflict is resolved or to terminate the request to restore.
To delete out of the command, press D E L E T E . If this does not stop the
command, you may need to press C ON T R O L and backslash simultaneously.
If, while running restore, you want to abort the command, a message similar
to the following may appear:
At the user’s request, administration of the following
cmd(s) has been interrupted.
CARD NUMBERS: <card numbers>
To assure proper operation of the identified card(s),
run diagnostics at the earliest opportunity.
When restore is aborted, you should diagnostics on all cards being
administered to ensure that they are returned to a fully functional state.
Example
The following example restores card 0 to service.
restore card 0
The following example restores channels 0, 1, and 5 to service.
restore channel 0-1,5