HP R4.2 - Manual (Page 596)

A
Summary of Commands remove
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 557
• immed — Removes a card or channel even if it is in use. Active calls are
likely to be dropped when this option is specified. This option is
necessary when the card or channel must be removed from service as
soon as possible, and you are willing to terminate any active calls. You
may also want to use this option to get control of a channel that is hung
and not providing useful service.
• min_delay — Used to avoid waiting for channels to be granted. This
option applies to remove chan and remove card requests that are
removing network interface channels, for example, T1. This option
specifies to minimize the delay in removing channels from service by not
waiting for the channel to be granted. This option speeds up execution of
the remove command, especially when a large number of channels are
currently active.
When using this option, you must display the status of the channels with
the display card command to determine when they are in the MANOOS
state. This option can be used with or without
the immed option and
improves the response time in either case.
! CAUTION:
Removing a large number of channels from service with the min_delay option
may cause momentary load problems on the switch.