HP R4.2 - Manual (Page 598)

A
Summary of Commands restore
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 559
See Also
attach
detach
restore
restore
The restore command restores a unit to the in-service state.
Synopsis
restore <unit> <number> [-i] [-n]
Description
The restore command is used to change the permanent state of a unit from
manual-out-of-service (MANOOS) to in service (INSERV). The specified unit
is placed in the INSERV state unconditionally, unless its current state is not
MANOOS.
The parameters for the restore command are:
• <unit> — Identifies the unit. The choices are “channel” or “card.”
• <number> — Specifies the channel or card number, a range of channel
or card numbers in the form m-n, or the word “all” for all the channel or
card numbers. Card numbers are in the form card#[.port#]
where port# is