Nortel Networks 9150 - Manual (Page 145)

Remote Gateway 9150 Installation and Administration Guide 115
January 2005 Installing the Remote Gateway 9150 unit
Using the Configuration Wizard to perform
initial configuration
The Configuration Wizard option in Configuration Manager allows you to
configure the minimum information needed for establishing communications
between the Remote Gateway 9150 unit and the RLC at the host site. The
Configuration Wizard does not provide all the configuration settings that are
available in Configuration Manager. By using the Configuration Wizard, the
Remote Gateway 9150 unit can be up and running within 10 minutes.
You can use the Configuration Wizard in offline mode or while connected and
logged on to the Remote Gateway 9150 unit (online mode).
What you can configure with the Configuration Wizard
The Configuration Wizard allows you to configure the following:
!
the Remote Gateway 9150 unit’s IP address, subnet mask, and default
gateway
This information must be valid for your IP network.
Note: If you are not planning to use the IP network to route calls, you must
enter this information for administrative purposes. If you do not have an IP
network in place, use the sample information provided on page 119.
!
for Voice over IP capability: the IP address for the RLC at the host site
!
for PSTN capability:
— the telephone number of the RLC at the host site
— information provided by your ISDN service provider for each ISDN
BRI trunk interface module (telephone numbers, SPIDs, and switch
type)
Ensure you have this information ready before you begin.
Note: If, after completing configuration with the Configuration Wizard, you
want to modify any settings, you must use Configuration Manager.