Nortel Networks 9150 - Manual (Page 229)

Remote Gateway 9150 Installation and Administration Guide 199
January 2005 Configuring the Remote Gateway 9150 unit
Configuring the RLC connection information
To configure the RLC connection information:
1 Complete the fields as described in “RLC Connection Configuration field
descriptions” on page 203.
2 Click on the OK button
Result: Configuration Manager writes the changes to a temporary file on
the administration PC.
3 Click on the Send button to update the Remote Gateway 9150 unit with the
new information.
Note: To save changes to the Remote Gateway 9150 unit’s Flash memory,
select Upload
→ Save to Flash from the Menu Bar.
PSTN connection configuration
The PSTN number configured on this property sheet corresponds to the
dedicated network port on the RLC for your Remote Gateway 9150 unit. The
PSTN number to connect to the RLC must be configured in a specific manner. If
you select Caller ID as the security level, then the PSTN number that you enter
for the Remote Gateway 9150 unit to connect to the RLC is compared with the
telephone number configured on the RLC for your site. If the two numbers do
not match, the call is dropped.
Note: Enter the PSTN number to connect to RLC exactly as it must be dialed by
the Remote Gateway 9150 unit, including 1 for long distance and 9 for Centrex
trunk access.
Permanent PSTN connection
When using multiple Remote Gateway 9100 Series units, you must only
configure the permanent PSTN connections for the RLC’s primary network
ports. If you only use one Remote Gateway 9100 Series unit, you can use
additional permanent PSTN connections.