Nortel Networks 9150 - Manual (Page 223)

Remote Gateway 9150 Installation and Administration Guide 193
January 2005 Configuring the Remote Gateway 9150 unit
Configuring the IP addresses
To configure the IP addresses:
1 Complete the fields as described in “IP Configuration field descriptions” on
page 193.
2 Click on the OK button.
Result: Configuration Manager writes the changes to a temporary file on
the administration PC.
3 Click on the Send button to update the Remote Gateway 9150 unit with the
new information.
Notes:
a. When you change IP configuration parameters and Save to Flash, calls
can be dropped. Ensure that there are no active calls when you make
changes to these parameters.
b. To save changes to Flash memory, select Upload
→
Save to Flash
from the Menu Bar.
IP Configuration field descriptions
Field Description
IP Address Enter the IP address of the Remote Gateway 9150 unit.
IP Network Mask Enter the subnet mask of the currently logged-on Remote
Gateway 9150 unit. The subnet mask identifies to the Remote
Gateway 9150 unit which portion of the IP address represents
the network and which portion represents the host.
IP Gateway Enter the IP address of the IP gateway serving the Remote
Gateway 9150 unit. A gateway is a device that functions as a
node on two networks, forwarding packets from one network to
addresses on the other networks. In Remote Gateway 9100
Series context, the gateway is the device on the network that
directs traffic to and from the Remote Gateway 9150 unit.