Nortel Networks 9150 - Manual (Page 420)

390 Remote Gateway 9150 Installation and Administration Guide
Sample configuration files Standard 3.1
Example of a network
This section provides an example of a network diagram that shows one host site
(with one RLC installed on the host PBX) and one Remote Gateway 9150 unit
(with one user station). The purpose of this diagram is to demonstrate the
relationship between configuration settings on each unit in the network.
Sample configuration printouts
Sample Meridian 1 PBX configuration printouts for the voice and data ports are
provided as follows:
!
voice port: on page 392
!
data port: on page 394
Sample configuration printouts for the RLC and Remote Gateway 9150 unit are
shown as follows:
!
RLC: on page 396
!
Remote Gateway 9150 unit: on page 400
Configuration recommendation
The quickest way to configure the RLC and Remote Gateway 9150 unit is to run
the Configuration Wizard. For instructions, refer to “Using the Configuration
Wizard to perform initial configuration” on page 115. For your reference, the
Configuration Wizard screen examples are completed using the same
information.
Note: The network diagram shows information that cannot be configured
through the Configuration Wizard, such as the security identifiers. You must use
Configuration Manager to complete the configuration.