Nortel Networks 9150 - Manual (Page 426)

396 Remote Gateway 9150 Installation and Administration Guide
Sample configuration files Standard 3.1
RLC configuration
This section shows the configuration settings for the RLC. You can obtain a
similar configuration printout by performing a configuration download while
connected to the RLC.
Note: Configuration settings are separated by commas (,).
Configuration example
This configuration example uses the settings identified in the network diagram
shown on page 391.
IPCFG 10.2.1.1,255.255.0.0,10.2.1.10,10.3.1.2,255.255.0.0
APPMODCFG 0,NC,NC
APPMODCFG 1,E,G729A,G729A
APPMODCFG 2,NC,NC
APPMODCFG 3,NC,NC
APPMODCFG 4,NC,NC
APPMODCFG 5,NC,NC
APPMODCFG 6,NC,NC
APPMODCFG 7,NC,NC
SYSCFG 1,HOST1
RLCCFG E,E
ACCFG D
PORTCFG 0,1,0,2,2,D
PORTCFG 1,1,0,2,2,D
PORTCFG 2,1,0,2,2,D
PORTCFG 3,1,0,2,2,D
PORTCFG 4,1,0,2,2,D
PORTCFG 5,1,0,2,2,D
RLC’s IP address information:
! IP address
! Subnet mask
! IP gateway
! Management IP address
! Management subnet mask
DSP application module
(only module 1 is configured in
this case)
Unit ID and node name
Ports configured as remote ports