Nortel Networks 9150 - Manual (Page 480)

450 Remote Gateway 9150 Installation and Administration Guide
Display log definitions Standard 3.1
Statistic Definition
LOG NUMBER 55
DESCRIPTION This log indicates the system was unable to place a voice call,
which could be caused by the following conditions:
1) No connection to the remote. Attempts failed.
2) HIGH/NORMAL priority: No bandwidth on trunk and IP not
available.
3) PSTN only call: No bandwidth available, trunk disabled, or trunk
not reachable.
4) IP only call: IP not reachable or not enabled.
5) Some inconsistency within the system - Synchronization
between RLC - 9150/911x.
SEVERITY NORMAL
TASK Network Manager
PRODUCT RLC
CANCELLATION None
ACTION TO BE TAKEN 1) Verify correctness of configurations.
2) Verify physical connections on the medium according to
information in 1), above.
Note: If this happens consistently for all calls, and is not an
obvious problem due to configuration or bandwidth limitations,
view the statistics and report the problem.
PARAMETERS 1) Remote Gateway 9100 Series unit ID
2) amount of bandwidth the system needs to place the additional
call
DISPLAYED TEXT Voice call did not succeed to Remote Site: P1 [BW required P2]