Nortel Networks 9150 - Manual (Page 150)

120 Remote Gateway 9150 Installation and Administration Guide
Installing the Remote Gateway 9150 unit Standard 3.1
2 After reviewing the message, click on the Next button.
Result: The Configuration Wizard screen displays, similar to the following:
3 Verify that the Currently Logged in Device drop down box shows 9150. If it
does not show 9150, select 9150 from the drop down list.
4 Click on the Next button.
Result: The Local Unit Configuration dialog box displays. A completed
example is shown on page 122.
5 Complete the fields on this dialog box as described in the following table:
Field Description
Set the unique Unit ID of the
unit Enter the number from 1–255 that uniquely
identifies the Remote Gateway 9150 unit
you are configuring for a particular RLC.
Note: Each unit connected to a RLC must
be given a unique unit ID. This implies that
Remote Gateway 9150 units that connect
to different RLCs in the network can have
the same unit ID.
Ensure that
the Device
field shows
9150.