Nortel Networks 9150 - Manual (Page 415)

Remote Gateway 9150 Installation and Administration Guide 385
January 2005 Planning forms
Remote Gateway 9150
System expansion worksheet
Page 1 of 4
Complete one worksheet for each Remote Gateway 9150 unit.
Number of simultaneous fax calls
1 How many simultaneous faxes do you want your equipment to support?
Multiply the number of simultaneous faxes by two to determine the total number
of DSP channels required for fax calls. (Each fax call requires two DSP
channels.)
_______ x 2 = _______
___________
Notes:
! If the number of DSP channels required for fax calls is not divisible by four,
round up the number entered in step 1 to the next multiple of four. (Each
DSP device contains four channels.)
! Always round up to a higher number.
2 Divide your Step 1 answer, the total number of DSP channels required for fax
calls, by four to determine the number of DSP devices required for fax calls.
(Configuration Manager assigns DSP function on a per-device basis.)
Step 1: _______ / 4 = _______
Note: This calculation assumes G.729A/FAX compression. For G.711 or
G.726, divide by four.
___________
Number of stations:
3 How many digital telephones will be installed at the Remote Gateway 9150
site?
Note: A maximum of 32 digital telephones can be connected to the Remote
Gateway 9150 unit.
___________
4 How many Analog Telephone Adapters (ATAs) will be installed? ___________
5 How many Meridian Communication Adapters (MCAs) will be installed? ___________
6 Add lines 3 and 4 together. ___________
Notes:
! A maximum of four MCAs and ATAs can be installed when connecting the
Remote Gateway 9150 unit to a 1-slot RLC. A maximum of seven MCAs and
ATAs can be installed when connecting to a 2-slot RLC.
! The total number of ATAs and digital telephones cannot exceed 32.
___________
7 Will a fax machine be used for faxes through the host PBX?
❒
Yes
❒
No
8 If line 7 is Yes, add 2 to line 6. ___________